Maintenance of fire service

1.take off after each use, check the condition of the fire service, focus on checking for wear.
2. if you want to remove residual dirt on the fireman equipment, with tap water and a mild soap, detergent if necessary.

Detergent used only in contaminated site, be careful, because detergents may damage the aluminized surface.
3. if the fire service has been and chemical exposure, or found to have a bubble phenomenon, you should clean the entire

aluminum surface. If oil or grease left on the fire service residue, then use a mild soap for cleaning.
4. fireproof clothing store before re sure to thoroughly dry, dry good is best not to fold.
5. if the surface of the fire service's thrown a small area is not very serious burn marks or wear and tear, you can use

aluminum gun repair. If there is damage to the external fire service, will have to replace the fire service.

Introduction of fire service

Fire service is referring to the United States NFPA1951-2001 Standards,Reference date The fire rescue service design and production of a new generation of fire rescue services. This firefighter gear has the following characteristics:
1 Shoulder, back, elbows, knees, hips and other parts are designed with reinforced layer, reinforcing area Total body area 40% Above;
2 Domestic first designed in cooperation with the fire department in Japan and exported to Japan disaster relief services;
3 360 Degree reflective design;
4 Permanent flame retardant, washable up 50 More times;
5 State Seismological Bureau rescue team used exclusively.